| 释义 |
test specimens短语¹³¹⁶²⁰⁺³
基本例句
🌏检验试片
A portion of material taken to represent the lot sample, or the original material, and used in the laboratory as a source of test specimens.
部分材料将作为批样或原始材料，且用于实验用试样的来源。 www.1x1y.com.cn
Support the panel with the thermometer attached in the specimen drum or rack in the same manner as the test specimens so that it will be subjected to the same influences.
用温度计以相同的方式测量面板鼓或机架的温度，看这两个被试的温度是否受到了同样的影响。 suiniyi
The numerical calculating results agreed well with the test data. The parameters affecting the web crippling capacity are researched through a series of numerical test specimens.
系列数值分析表明影响槽钢腹板压屈的主要参数是腹板的厚度、屈服强度、槽钢的内角半径。 fabiao
The qualified rate of the tension test specimens that is produced by this permanent mold rises from50% to90%, and their mechanical properties exceed national standard.
采用这种金属型生产出来试样，合格率从50%提高到90%，而且力学性能超过国标要求。 chemyq
Upon satisfactorily completion of the required visual inspection and PWHT, the coupons shall be sent for machining for preparation of test specimens.
目视检验合格，完成后焊热处理之后，附体试片应转送加工，作为试件样品使用。366translation
For test specimens built up symmetrically from16 layers of fiber reinforced material the stress distributions are calculated under axial and thermal loads.
本文对用16层纤维增强材料对称铺设成的试样，在轴向载荷和热载下的应力分布作了计算。 cnki
In this paper, the transient response of the dynamic-tear- test specimens under impact loading is analyzed by means of dynamic photoelasticity.
本文用动光弹方法分析了动态张开型试件在冲击载荷作用下的瞬态反应。 cnki
Other procedures for preparation of test specimens may be used if agreed upon by all interested parties.
若有关各方一致通过，也可采用其它方法来制备试样。 www.instrument.com.cn
The fracture features of Charpy impact test specimens of welded metal are also analyzed.
文中还对焊缝夏比冲击试样的断裂特性进行了探讨。 chemyq
This test piece shall be welded using the identical welding parameters as the original test and only weld metal impact test specimens shall be tested.
此试件应使用与原始试验相同的焊接参数进行焊接，并且仅对焊接金属冲击试样进行试验。 cadjy
Two kinds of adiabatic shear bands were found in the post- test specimens impacted by spherical bullet and Hopkinson pressure Bar.
结果发现，该合金在两种试验条件下形成两种绝热剪切带。 www.rmme.ac.cn
Test results indicated that the test specimens have good behaviors such as proper stiffness, considerable capacity of deformation and energy dissipation.
试验结果表明：试件具有较大的初始刚度，并具有良好的延性与耗能性能。 chinalivingsteel |