| 释义 |
su·per·al·loy 英ˈsuːpəˌælɔɪ美ˈsupɚˌælɔɪAHDs›“pər-ăl'oi 高COCA¹³¹⁸⁶²BNC²³⁶²¹³⁺¹iWeb⁵²⁷⁷⁹
基本例句
n.超耐热不锈钢¹⁰⁰复数superalloys High temperature stress rupture behaviour of single crystal Ni- base superalloy prepared by different withdrawal rate has been studied.
研究了不同拉晶速率下制得的镍基单晶高温合金的高温持久变形行为。 cnki
The abnormal large- volume inclusion defect existing in certain P/ M superalloy product was researched and its institution, forming reason was also analyzed.
本文研究了镍基粉末冶金高温合金个别制件中出现的异常大尺寸夹杂物缺陷，分析了它的成分、形成原因。 dictall
The critical deformation and forgeability of the spray formed superalloy were studied by wedge specimen and column specimen.
采用楔形试样和圆柱形试样分别研究了合金的临界变形和变形塑性。 dictall
The formation of the microstructure and the evolution process from dendrite into equiaxed structure during atomized process for spray formed superalloy were analyzed.
对喷射成形高温合金的组织形成及其从雾化过程的树枝晶向等轴晶组织的演变过程进行了分析。 cnki
The formulation of life prediction for specified program-controlled temperature cycle is proposed. The fracture surface of the superalloy has also been observed by SEM.
提出了特定程序波温度循环预测合金断裂寿命的公式，并用扫描电镜观察了合金的断口。 cnki
The products by ESR include243 designations of steel and superalloy.
产品包括优质合金钢与超级合金243个牌号。 cnki
The progress of rotary casting for reducing nonmetallic inclusion in superalloy was briefed. The two key techniques were the design of casting system and the establishment of rotating process.
简要叙述了用旋转铸锭工艺减少高温合金中非金属夹杂物技术的发展，以及该工艺的两项关键技术即浇注系统设计及旋转制度的确定。 chemyq
The wide range of investigations shown shut lower yield strength, coarse grain size and metallurgical flaws were the basic causes for the earlier failure of superalloy for turbine disk.
广泛的研究表明，屈服强度低、粗晶粒尺寸、冶金缺陷的存在是造成涡轮盘用高温合金早期失效的主要原因。 cnki
Transformation mechanism of carbides and their effect on the stress rupture property were investigated in a Ni- base single crystal superalloy with microcontent of carbon.
碳的镍基单晶高温合金在热处理和持久过程中的碳化物演化机制以及各种碳化物对合金持久性能的影响。 dictall
A Ni base superalloy columnar preform were produced through nitrogen spray atomization and deposition.
利用氮气雾化喷射沉积技术成功地获得了宇航用变形镍基高温合金柱形坯。 iciba
Addition of Hf to a superalloy is one of the effective approaches to improve its mid- temperature properties.
添加铪是改善合金中温性能的有效途径之一。 iciba
By means of the measurement of creep curves and microstructure observation, an investigation has been made into the microstructure and creep behaviors of FGH95 powder nickel- base superalloy.
通过进行蠕变曲线测定和组织形貌观察，研究了FGH95粉末镍基合金的微观组织结构与蠕变行为。 dictall
By using physicochemical phase analysis, the phase in a new directionally solidified superalloy resisting combustion gas corrosion with long life had been determined qualitatively and quantitatively.
采用物理化学相分析方法，对一种新研制的抗燃气腐蚀长寿定向凝固合金的相作了定性和定量分析。 cnki
Grain growth behavior and its kinetics during heat-treating process of FGH96 superalloy have been investigated.
对 FGH96合金在热处理过程中晶粒长大规律进行了系统的研究。 cnki
Heat treatment conditions of the superalloy4 have been determined by the analysis of the differential thermal curveDTA.
通过差热曲线分析和组织形貌观察，确定出合金4的热处理工艺； cnki
In order to improve the property of nickel base superalloy K38 used at high temperature, tests of hot dip with Al- Si- RE and oxidation resistance had been performed.
为了提高镍基高温合金 K38的高温性能，我们对 K38合金进行了热浸镀铝-硅-稀土处理，并进行了抗高温氧化试验。 cnki
In order to study the fracture mechanism of IC6 superalloy, the tensile process of alloy was observed by back scatter image in situ.
为了研究 IC6合金的断裂机制，用背散射电子图像原值观察该合金的动态拉伸过程。 cnki
The results can meet the requirements about qualitative analysis and semi- quantitative analysis of tungsten in superalloy.
研究结果可用于高温合金中钨元素的定性和半定量分析及材料牌号鉴别。 chemyq
The study proved that is quite adequate for the analysis of ceramic inclusions in superalloy powders, which can vary either in size or in morphology.
研究表明，用水浮选法分析高温合金粉末中的陶瓷夹杂含量，其方法是可行的，而且适用于分析各种不同粉末粒度和形状的合金粉末。 iciba
The impact toughness of the superalloy increased with the increase of the grain size on the premise of less changing of intragranular precipitation, grain boundary precipitation, etc.
在晶内、晶界沉淀等因素变化较小的前提下，随晶粒几何尺寸增大，合金的冲击韧性升高； cnki |