| 释义 |
finite element短语⁹⁶⁶⁷⁷⁺⁶
基本例句
有限元
A nonlinear finite element analysis of4 RC deep flexural simply supported beams with the program VT2 is presented.
使用基于扰动应力场模型的非线性有限元程序 VT2分析了4个深受弯简支梁的受力性能。 iciba
A tentative numerical example shows that the above class of EBE computational methods for finite element structural analysis is very efficient for both sequential and parallel computing.
初步数值试验结果表明：这类 EBE有限元结构分析方法对串行和并行计算都是很有效的。 iciba
So how to generate adaptive finite element mesh that can reflect physical and geometric characteristics of the structure is a necessary step to apply AFEA.
生成反映结构物理特征和几何特征的自适应有限元网格是应用自适应有限单元法的必要环节。 iciba
The similarity between equivalent stress distribution around the holes in cylindrical shell and its plate model is shown through finite element analysis.
有限元分析表明，开孔圆柱壳与其相应的平板模型在开孔附近的等效应力分布非常相似。 cnki
To save computer storage, the paper uses method of condensing all the unknowns in domain of boundary element to coupling surface to realize couple between finite element and boundary element.
本文采用了将边界元区域的全部未知量凝聚到耦合面上的方法来实现有限元与边界元的耦合，从而达到节省内存的目的。 cnki
A static finite element model of an air spring was given.
文中建立了空气弹簧的静态有限元模型。 iciba
Based on this assumption, the2.5 D finite element basic formulas had been established and compiled the FEM program by FORTRAN.
在这个前提下，推导了2.5维有限元的基本公式，并用 FORTRAN语言编制了计算程序。 iciba
Based on completion of wall strength calculation, then do the finite element stress analysis.
在完成管壁强度计算的基础上，进行管壁有限元应力分析。 cnki
By finite element analysis of circular conical shell, the natural frequencies and vibrational modes of Yongle Bell have been calculated.
本文通过旋转壳体的有限元方法，计算了永乐大钟的主要固有频率和振型。 iciba
Finally, a good many factors that cause the error to the outcome of finite element analysis method are analyzed and discussed.
最后，对有限元分析结果产生误差的诸多因素进行了定性分析和讨论。 iciba
In this paper, calculation of load performance of a 28V,35A claw- pole alternator is presented using three dimensional finite element method with tetrahedral edge elements.
本文用四面体棱单元三维有限元方法计算一台28V，35A汽车用爪极发电机负载特性。 http://dj.iciba.com
The finite element method was used for analysis of heat stress in chip on board COB.
本文采用有限元法分析了板上芯片 COB的热应力分布。 iciba
With RDW being 5,6.5 and8, three specimens are discussed in detail about the comparison of finite element analysis results and the experiment results.
通过试验结果与有限元分析的对比，给出了肢厚比为5，6.5和8三种情况下矩形截面试体应变演化全过程。 iciba
Finite element method is applied for the calculations of temperature fields of concrete filled steel tubes under fire.
这篇论文主要研究火灾时钢管混凝土柱温度场计算中有限元方法的应用。 wenkuwu |